Thank you for your patience while we retrieve your images.
Taken 3-Oct-15
Visitors 336


Making the cut

This image shows both the bare chassis, and the mill set up used to cut the notch for the carb manifold. You see, I failed to chess this thing out, and notice that the carb wouldn't fit inside the frame, so something had to give.
You can also see how many notches were necessary to get the engine to fit.
I should add that the 3" tube spine frame is actually the gas tank. Not kidding. The fuel will be pumped up to the carb with a vacuum pulse pump from a personal watercraft. The gas cap is the shiny thing on the right.
Apple iPhone 5s, f/2.2 @ 4.15 mm, 1/30, ISO 80, Flash

Making the cut